Hej.
- Wyjmujesz zbiornik i zostawiasz 600ml wody.
- Dodajesz nakrętkę Dezcala i mieszasz (umieść pojemnik w maszynie)
- Załącz Casę i spuść ok 500ml (bojler ma 450ml) przez dyszę pary włącznikiem wody (nie kawy i nie pary).
- Poczekaj aż wyłączy się światło podgrzewania.
EDYTA...
- Załaduj ślepe sito do PFa, zapnij te kolbę i 3x po 20 sek załącz przycisk parzenia kawy
KONIEC EDYTY...
- Wyłącz maszynę i daj jej godzinę.
- Wymyj zbiornik na wodę i wlej do pełna
- Włącz maszynę i spuszczaj wodę przez dyszę pary na przemian z grupą. Tak ze 3 zbiorniki wody.
Chyba już...
Trochę pomyliłem, pisząc z poczekalni od pana dr.Oj Boli...
A tu masz oryginał z manuala CASY
"1 Dissolve the descaler in water according to the instructions for use (see above) and pour the solution into the
water tank. Switch on the machine.
2 Release a minimum total of 400-500 ml of water from the brew group and from the steam/hot water dispenser.
Thus, the boiler is filled with descaler. Then heat up the machine to operating temperature.
3 Place the portafilter with the blind filter into the brew group and operate the coffee button (Image 1 – no.6). 3 times
for about 20 seconds each time. Switch off the coffee button after every operation. This descales the expansion
valve.
4 After this process, let the descaler react for approx. ½ hour.
5 Release the remaining descaler solution by operating the coffee button.
6 Switch off the machine, remove and clean the water tank and fill it with fresh water.
7 Switch on the machine and release approx. 400-500 ml of water from the group and the steam/hot water valve
(switch pump).
8 Clamp the portafilter with the blind filter back into the brew group and activate the coffee button 3 times for
approx. 20 seconds. This descales the expansion valve.
9 Repeat the process of pos. 7 approx. 4 times to make sure that no descaler is left in the boiler.
10 Then remove the blind filter from the portafilter."...